Total Roof Services

Tile Roof Maintenance: Caring for Concrete and Clay Tile in Central Florida

The tile outlasts almost everything around it. Here is what to check, how often, and why the underlayment underneath decides how long the roof lasts.

Roof maintenance

InspectTwice a yearplus after named storms
Wears firstUnderlaymentnot the tile
Walk on itDon’tfoot traffic cracks it

Sources: Eagle Roofing Products, Tile Roof Maintenance (March 31, 2016); National Park Service, Preservation Brief 30: Clay Tile Roofs.

Tile roof maintenance is less about the tile than about everything around it. Concrete and clay roof tile shrugs off the sun and heat that wear out a shingle roof, and the National Park Service’s brief on clay tile roofs says the tile itself, correctly installed, “requires little or no maintenance.” What needs looking after is what the tile protects and what holds it down: the underlayment underneath, the flashing at walls and valleys, the mortar or foam at the hips and ridge, and the gutters that carry the water away. Eagle Roofing, a concrete tile maker, recommends inspections twice a year.

This guide covers roof tile maintenance for Central Florida homes: what to check and how often, why the tile should never be walked on, how a tiled roof should be cleaned, and when repairs stop being enough. For how we install, repair and re-lay concrete and clay tile, see our tile roofing page.

What a tile roof actually needs

Tile is a rain screen, not the waterproof layer. It sheds most of the rain and shades what is beneath it, but wind-driven rain, water running sideways at a valley and Florida’s humidity all reach the underlayment, and the underlayment is what keeps the house dry. On older tile roofs that is felt or a hot-mopped membrane that dries and cracks after decades of heat under the tile, while the tile above looks the same as the day it was set.

That is why maintenance on a tile roof focuses on keeping water moving and keeping the field intact. The NPS brief puts the usual failures in the same places: the fastening system, metal flashing, valleys and gutters. It also notes that gutters and downspouts allowed to fill with debris back water up under the tiles, where it slowly damages battens, sheathing and fasteners. None of that is visible from the street until a ceiling stains.

The tile roof maintenance checklist

CheckWhat to look forHow often
Field tileCracked, slipped or missing pieces, seen from the ground with binocularsTwice a year, after storms and after any trade has been on the roof
Hips and ridgeCracked or missing mortar, loose or displaced ridge tileTwice a year and after high wind
ValleysLeaves and pine needles packed in the valley or behind tileTwice a year; more often under trees
Gutters and downspoutsDebris in gutters, crushed or bent downspout exitsTwice a year and after storms
FlashingLoose or lifted flashing at walls, chimneys and pipesEvery inspection
Roof planeAreas that look sunken, or water standing anywhereEvery inspection
AtticWater stains on the decking or rafters after a heavy rainAfter heavy rain
TreesBranches touching or overhanging the roofYearly

Sources: Eagle Roofing Products; NPS Preservation Brief 30.

Eagle suggests timing the two inspections for the end of winter and late summer. In Central Florida, that lines up neatly with before and after the worst of hurricane season. Its list also carries two practical warnings: don’t use a hose to push debris off the roof, because that can clog the downspouts, and report loose flashing to a roofing company rather than fixing it yourself. Trimming trees and shrubs back from the house cuts the shade and moisture that let mold and algae grow on tile.

The attic check is the one most owners skip and the one the NPS brief singles out: looking at the underside of the roof after a heavy rain for water stains can catch a leak early, before it becomes a larger repair. Leaves and needles trapped behind tile hold moisture against the underlayment, so we check for them whenever we repair or re-lay tile.

Shingle roof with copper-colored metal dormer roofs and gutters on a home with a wraparound porch
Gutters along the roof edge of a homeCentral Florida · residential

Keep people off the tile

Most tile damage we see was caused by people, not weather. A satellite installer, a pest control technician or someone cleaning the roof walks across the field, cracks a few tiles, and the cracks let water reach the underlayment for a year before anyone notices. The NPS brief makes the same point about clay: tiles are damaged by roofers walking carelessly on an unprotected roof, and high-profile barrel tiles are very fragile and easily broken.

A roofer who has to cross a tile roof walks on the lower third of each tile, where it is supported, never on the crown, and spreads the load. The NPS describes professionals using plywood sheets, planks or sandbags to distribute weight, or a ladder hooked over the ridge. If a contractor needs to go up for something unrelated to the roof, ask how they plan to move across it. After any trade has been on your tile roof, look from the ground for slipped or cracked pieces.

Cleaning a tile roof

Cleaning is part of tile roof maintenance in a humid climate, because mold, algae and dirt hide cracks and make it hard to see the condition of the tile. Eagle recommends having the roof cleaned before it is inspected, and having the cleaning done by a licensed and insured professional.

  • Ask how the cleaner will get around the roof. Walking the field to clean it is one of the commonest ways tile gets cracked.
  • Ask what products and pressure they use, and check them against the tile maker’s own guidance before work starts.
  • Have someone look for cracked or slipped tile once the roof is clean. A clean roof is the easiest time to spot damage.
  • Expect concrete tile color to fade and chalk over the years. That is mostly cosmetic; clay holds its color.

Clean gutters and downspouts at the same time, by hand, so the debris that comes off the roof does not end up blocking them.

Broken and slipped tiles

One cracked tile is a small repair; left alone, it is a hole in the rain screen over an underlayment that was never meant to take direct rain. The NPS brief says broken or damaged tiles should be replaced promptly, before they damage the tiles around them or the structure underneath. The hard part of replacing a single tile is getting it out without breaking its neighbors, which is a job for a roofer.

Matching is the other problem. Tile profiles and colors are discontinued, and a re-lay or repair depends on having enough matching tile on hand. If you have leftover tiles from the original installation stored in the garage, keep them: they are often the best match you will ever find. Before we promise a re-lay, we count the spares.

Tile roofs and hurricane season

NOAA dates the Atlantic hurricane season from June 1 to November 30, and storms leave a recognizable pattern on tile. Wind lifts and displaces ridge and hip tiles where the mortar has aged, and flying debris cracks field tile that then lets water in at the next storm. Before the season, have the hips, ridge and any loose pieces looked at. After a named storm, check from the ground for displaced or broken tile and look in the attic after the next heavy rain.

Many neighborhoods in Orlando, Winter Park and Kissimmee require tile by covenant, which makes replacing a broken piece with a matching one part of staying within the HOA’s rules. If storm damage needs documenting for an insurance claim, our storm damage page explains how we record it. For a whole-house routine that covers gutters, attic ventilation and the rest, see our roof maintenance checklist for Central Florida homes.

When maintenance is no longer enough

Because the tile outlasts the underlayment, a tile roof eventually reaches a point where maintenance cannot keep it dry. The clearest sign is leaks that show up in new places each rainy season under a field of tile that looks fine. At that point, another tile swap does nothing, because the membrane underneath has failed broadly. The two real options are a re-lay, where the existing tile is lifted, the underlayment, flashing and fasteners are replaced and the same tile goes back down, or a full replacement with new tile.

Florida’s residential code has its own re-roofing rules for tile, which our guide to international residential code roofing in Florida explains, and our roof replacement cost guide covers what drives the price of a new roof.

We maintain, repair and re-lay concrete and clay tile on homes across Central Florida, including roofs we did not install, and we photograph the underlayment so you can see what you are paying for. Our tile roofing page covers re-lay versus replacement in more detail, our roof inspection page explains what a visit includes, or you can schedule an inspection.

Common questions

Twice a year, plus after any named storm. Eagle Roofing, a concrete tile maker, recommends semi-annual inspections at the end of winter and toward the end of summer, which in Central Florida falls before and after the worst of hurricane season.

Only a roofer should, and carefully. Tile cracks easily underfoot, especially barrel profiles. A roofer steps on the lower third of each tile where it is supported, never on the crown, and spreads the load with boards or a ladder hooked over the ridge.

By a licensed and insured professional, as Eagle Roofing recommends, using methods the tile maker allows. Ask how the cleaner will move around the roof, since walking the field is a common cause of cracked tile, and have the roof checked for damage once it is clean.

The underlayment. The tile sheds most of the rain, but the membrane underneath is what keeps the house dry, and it dries and cracks under years of Florida heat while the tile above looks unchanged.

Yes. Profiles and colors are discontinued, and leftover tiles from the original installation are often the best match available for a repair or a re-lay.

Ready for a straight answer on your roof?

Book an inspection and we’ll document what we find, explain your options, and put a clear scope in writing.